LaRue handguard’s also include integral QD sling-swivel sockets at the base of each side for convenient mounting 2-point slings. The side and bottom rails are tucked closer to the barrel, keeping the profile narrower and more streamlined. Once properly installed, there is no chance of movement whatsoever. Our two-pin proprietary barrel nut system with its locking anti-slip plate, sets LaRue handguard’s apart from the competition. The 13.2’s length covers all gas blocks, including full-lengths, providing true free-float. Ideal for 16″-20″ barreled uppers that need maximum rail space. Here is the description straight from Larue Tactical: The LT15-13.2 also has a very comfortable profile. I had no intent on utilizing a front sight gas block so the 13.2″ length covers the Daniel Defense Low Profile Gas Block nicely. The main reason I believe was my good friend Rob at Ranier Arms planted a subliminal message that covering up as much barrel as possible would be most appealing to the eye. There were a few reasons I settled on the Larue unit. I finally narrowed it down to a Daniel Defense M4 12.0 Rail and LaRue Tactical AR 15 13.2 Handguard LT15-13.2 finally deciding to run with the Larue. This choice took me quite a while to decide upon. Note: The color issue is a colt specific issue from the early 1990’s LaRue Tactical AR 15 13.2 Handguard LT15-13.2 Neither did and the matte unit has been sent out for anodizing of the correct color Colt Gray. It was my hope that the color of one of the receivers would reasonably match the color of my Colt Sporter lower. One matte black and the other black teflon. I ended up purchasing two stripped upper receivers. With 6-groove, 1-7″ button rifling for accuracy and M4-type feed ramps for reliable feeding, these barrels help you reach out to distant targets with issued or magazine-length ammunition. 223 Remington and 5.56x45mm NATO ammunition. 223 Wylde chamber that helps maximize the long-range performance of your AR-15 with both. Precision-machined stainless steel barrels feature a. The barrel is bead blasted stainless steel. The White Oak Armament barrel has the Wylde Chamber. I was quite surprised to find Brownells had the White Oak Armament 16 Stainless Steel Match Grade Barrel in stock. White Oak Armament makes some of the finest AR-15 barrels in the business. Below is a list of the A-15 parts used in this project along with the rationale for their selection.Ĭolt Sporter Tactical AR-15 – Upper Receiver White Oak Armament 16 Stainless Steel Match Grade Barrel Because of this “Pre ban” status of this weapon I am able to customize this rifle with all the best upgrades that folks in other states take for granted. This weapon is a “registered assault rifle” in the eyes of the state. I was however, lucky enough to buy a Colt Match HBAR before the ban. Because this law was in place before the now sunset Federal Assault Weapon ban this ban will most likely remain in place forever. I have the unfortunate pleasure of living in a state that implemented its own version of an Assault Weapon Ban. It’s also important to note at the time this project was started it was very difficult to obtain AR-15 hardware. The change was not for anyreason other than internet friend Ernie aka Microgunner (RIP) got a few NIB units at his pawn shop. The Taclight has been replaced with a Surefire. It has been replaced with a Browe Sport Optic. My eyesight has gone downhill and I can no longer use the EOTech. It’s nice to see that in 2015 this build is still a very relevant and well though out project. Update: Aug– Interesting to look back at this project that was completed June 26, 2010.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |